Power source : 110VAC Or 220VAC
Power consumption: 3W
Contact capacity : SPDT 220VAC/5A 250VAC/ 220VAC/3A 250VAC
Rotary speed : 1 R.P.M.
Insulation test voltage: AC 1500V in 1 minute
Torque : 0.3~1N﹒ M
Specific gravity : 0.5g/cm3 0.3g/cm3
The torque spring is applied to adjust the shaft output torque force, which is set at “weak” position at
factory side, it is adjustable as per customer side target measuring material S.G.(special gravity),if the
measured material with higher S.G., please try to release it to more stronger spring force position step
until you found the proper orientation.
The paddle sensitivity will be interacted by weaker, otherwise, the low S.G. material will release
torque spring to the weakest position, which will cause the paddle performance to be more sensitive.
Note: the torque force should not be adjusted during test, avoiding the error check signal.
